This standard also mandates that frames will be delivered in order and connections should not see mis-ordering of packets. It includes automatic configuration of the aggregates, so minimal configuration of the switch is needed. When unplugging one of the cables, the failure will be detected almost instantly compared to ARP link monitoring.Ĩ02.3ad mode is an IEEE standard also called LACP (Link Aggregation Control Protocol). We will leave mii-interval to it's default value (100ms) MII monitoring is configured by setting the variables link-monitoring mode and mii-interval.Įnable MII Type1 interface bonding> set 0 interface bonding> set 0 link-monitoring=mii
Main disadvantage is that MII monitoring can't tell if the link can actually pass packets or not, even if the link is detected as being up.
#Switch mii instructions driver#
If device driver does not support this option then link will appear as always up. MII Type 1 - device driver determines whether link is up or down. MII monitoring monitors only the state of the local interface. Warning: When ARP monitoring is used, bonding slaves will send out ARP requests without a VLAN tag, even if an IP address is set on a VLAN interface in the same subnet as the arp-ip-targets
Unplug one of the cables to test if the link monitoring works correctly, you will notice some ping timeouts until arp monitoring detects link interface bonding> /pi 172.16.0.2 We will not change arp-interval value in our example, RouterOS sets arp-interval to 100ms by default. Having additional targets increases the reliability of the ARP monitoring.Įnable ARP interface bonding> set 0 link-monitoring=arp interface bonding> set 0 link-monitoring=arp arp-ip-targets=172.16.0.1 If only one target is set, the target itself may go down. It is possible to specify multiple ARP targets that can be useful in High Availability setups. Meaning of each option is described later in this article. Otherwise all replies from the ARP targets will be received on the same link which could cause other links to fail.ĪRP monitoring is enabled by setting three properties link-monitoring, arp-ip-targets and arp-interval. If balance-rr and balance-xor modes are set, then the switch should be configured to evenly distribute packets across all links. This also gives assurance that traffic is actually flowing over the links. It is not possible to use both methods at the same time due to restrictions in the bonding driver.ĪRP monitoring sends ARP queries and uses the response as an indication that the link is operational. In the above example, if one of the bonded links were to fail, the bonding driver will still continue to send packets over the failed link which will lead to network degradation.īonding in RouterOS currently supports two schemes for monitoring a link state of slave devices: MII and ARP monitoring. It is critical that one of the available link monitoring options is enabled. Note: bonding interface needs a couple of seconds to get connectivity with its peer.
Game saves will be saved exclusively on the Switch’s 32GB internal storage, with “re-downloadable” data (games, DLC) saved to microSD if available, or to the system’s internal memory if not.Note: Interface bonding does not create a interface with a larger link speed. It allows the Wii to be controlled mere moments after the On button has been pressed, before any IOS has been loaded and before the NAND filesystem has been read. When the backup is fully complete, exit the NAND backup screen by pressing any button.īootMii is a system designed by Team Twiizers to enable complete low-level control of the Wii.Select the BackupMii button (the one with the green arrow).Select the Options button (the one with the gears).Press the HOME Button, then select “Launch BootMii”.
0 kommentar(er)
